JVC VN-C20 Instructions Manual page 47

A
Control
B
Destination
Address
C
Destination Port
D
Frame Rate
Note:
● When the power of VN-C20 shuts down
accidentally during multicast transmission,
transmission will restart automatically when
VN-C20 is started up again.
For starting or stopping streaming.
Parameters that are set on the Streaming page will be saved when
transmission is started upon pressing the [Start] button.
For specifying the destination address.
Specify the multicast address. When other devices that make use of
multicast transmission exist, ensure that they are set to a different multicast
address.
For specifying the destination port number.
Set to an even number for RTP compliance. Odd numbers cannot be used.
When other devices that make use of multicast transmission exist, it is
recommended that they are set to a different port number.
Multiple multicast streams cannot be received on 1 computer when there are
duplicate port numbers.
Specify the frame rate when performing multicast transmission.
The actual frame rate used for transmission will be the upper limit in the
[Encoding] page even if a value that is larger than the frame rate in the
Encoding page is specified. (A Page 34)
47