Time Code; Tape Playback; Normal Playback - JVC GR-DX106/76AG Instructions Manual

During recording, a time code is recorded on the tape.
This code is to confirm the location of the recorded
scene on the tape during playback.
If recording starts from a blank portion, the time code
begins counting from "00:00:00" (minute:second:frame).
If recording starts from the end of a previously recorded
scene, the time code continues from the last time code
number.
To perform Random Assemble Editing (
time code is necessary. If during recording a blank
portion is left partway through the tape, the time code
is interrupted. When recording is resumed, the time
code starts counting up again from "00:00:00". This
means the camcorder may record the same time codes
as those existing in a previously recorded scene. To
prevent this, perform "RECORDING FROM THE
MIDDLE OF A TAPE" in the following cases;
• When shooting again after playing back a recorded
tape.
• When power shuts off during shooting.
• When a tape is removed and re-inserted during
shooting.
• When shooting using a partially recorded tape.
• When shooting on a blank portion located partway
through the tape.
• When shooting again after shooting a scene then
opening/closing the cassette holder cover.
Display
12 : 34 : 24
Frames are not displayed
during recording.
RECORDING FROM THE MIDDLE OF A TAPE
1
Play back a tape or use Blank Search (
find the spot at which you want to start recording, then
engage the Still Playback mode (
Playback").
2
Set the Power Switch
pressing down the Lock Button
switch, then start recording.
NOTES:
The time code cannot be reset.
During fast-forwarding and rewinding, the time code
indication does not move smoothly.
The time code is displayed only when "TIME CODE" is
set to "ON" ( pg. 35).
EN
14
TAPE RECORDING

Time Code

pg. 41 – 43),
Minutes
Seconds
Frames
(25 frames = 1 second)
pg. 14, "Normal
@
to " " or " " while
$
located on the
1
Load a tape (
2
Set the VIDEO/MEMORY Switch
then set the Power Switch
down the Lock Button
playback, press 4/6
• To stop playback temporarily (Still Playback), press
!
.
4/6
• To stop playback, press 5
• Turn the SHUTTLE SEARCH Ring
counterclockwise (2) and release to rewind, or
clockwise (3) and release to fast-forward the tape
during Stop mode.
• High-speed picture search (Shuttle Search) is
possible by turning the SHUTTLE SEARCH Ring
counterclockwise (2) or clockwise (3) during
playback (holding the SHUTTLE SEARCH Ring
continues search until released).
• Press the Zoom Button T
zoom in (up to 50X*/80X**), or W
can also magnify a particular part of an image
( pg. 39).
* GR-DX76 only
**GR-DX106 only
• At any time, pressing 4/6
playback.
Slow-Motion Playback/Playback Special Effects/
Playback Zoom:
Available only with the remote control (
To Control The Speaker Volume:
..... press VOL. +
turn down the volume.
During Shuttle Search, parts
of the picture may not be
clearly visible, particularly on
the left side of the screen.
pg. 15) to

Normal Playback

pg. 9).
t
@
to " " while pressing
$
located on the switch. To start
!
.
7
.
#
Y
on the remote control to
T
to zoom out. You
!
resumes normal
e
to turn up the volume, or –
ATTENTION

TAPE PLAYBACK

to "VIDEO",
#
#
pg. 39)
w
to