Loading Originals In The Document Processor - Kyocera TASKalfa 265ci Operation Manual

Common Operations > Loading Originals

Loading Originals in the Document Processor

The document processor automatically scans each sheet of multiple originals. Both sides of two-sided originals are
scanned.
Originals Supported by the Document Processor
Weight
Size
Capacity
Originals Not Supported by the Document Processor
• Soft originals such as vinyl sheets
• Transparencies such as OHP film
• Carbon paper
• Originals with very slippery surfaces
• Originals with adhesive tape or glue
• Wet originals
• Originals with correction fluid which is not dried
• Irregularly shaped (non-rectangular) originals
• Originals with cut-out sections
• Crumpled paper
• Originals with folds (Straighten the folds before loading. Failure to do so may cause the originals to jam).
• Originals bound with clips or staples (Remove the clips or staples and straighten curls, wrinkles or creases before
loading. Failure to do so may cause the originals to jam).
How to Load Originals
IMPORTANT
Before loading originals, be sure that there are no originals left on the original eject table. Originals left on the
original eject table may cause the new originals to jam.
1
?
50 to 120 g/m² (duplex: 50 to 110 g/m²)
Maximum A4 to Minimum A5
Maximum Legal to Minimum Statement
Plain paper (80 g/m²), Colored paper, Recycled paper, High quality paper: 50 sheets
Plain paper (105 g/m²): 37 sheets
Thick paper (120 g/m²): 33 sheets
Art paper: 1 sheet
Adjust the original table size.
3-11