Table of Contents
Advertisement
1
ShoreTel Mobility Router 6000 Installation
Connecting Power
1.8
Connecting Power
There are two power connections on the rear panel of the Mobility Router to ensure failover
functionality. To connect AC power:
1
Insert the female end of the power cord into one of the two power connections on the
rear panel of the Mobility Router.
2
Insert the other end of the power cord into an AC power source.
3
Repeat Steps 1 and 2 to connect the other power connector with an appropriate, separate
AC power source for full failover functionality.
Figure 1-8. Connect Power
4
On the front panel, press the Power button in the upper right corner.
Figure 1-9. Apply Power
5
As the Mobility Router starts up, messages display in the terminal emulation software
window. Use the initial configuration wizard to initially configure the Mobility Router
with
10
ShoreTel Mobility Router 6000 Series Hardware Installation Guide
"Using the Initial Configuration Wizard" on page
12.
Advertisement
Table of Contents
