1.10 Using The Initial Configuration Wizard - ShoreTel Mobility Router 6000 Series Installation Manual

1
ShoreTel Mobility Router 6000 Installation
Using the Initial Configuration Wizard

1.10 Using the Initial Configuration Wizard

In the terminal emulation software window, use the initial configuration wizard to initially
configure the Mobility Router. After initially configuring and restarting the Mobility Router,
access the RoamAnywhere Administration Portal to configure, manage, monitor, and
troubleshoot the Mobility Router.
Before starting the wizard, have the following information available:
Mobility Router hostname

If not using DHCP:






Password for administrative access to Mobility Router

To use the initial configuration wizard:
1
At the login prompt, type admin and press Enter.
2
When prompted to accept the End User License Agreement, enter YES to accept. The
initial configuration wizard starts.
3
Enter Y to use the wizard.
4
Enter the DNS hostname of the Mobility Router. The hostname can be in short-name
format or a fully qualified domain name.
5
At the 'Use DHCP on ETH0' interface prompt, do one of the following:


NOTE
Router does not change. If using DHCP , make sure to reserve an IP address for the
Mobility Router.
6
Enter the Mobility Router's primary IP address.
NOTE
7
Enter the subnet mask in the format of a 32-bit mask or classless interdomain routing
(CIDR) notation.
8
Enter the IP address of the default gateway for the Mobility Router.
9
Enter the IP address of the primary DNS server.
12 ShoreTel Mobility Router 6000 Series Hardware Installation Guide
Mobility Router IP address
Subnet mask
Default gateway for Mobility Router
IP address of primary DNS server
Domain name for the Mobility Router
To use DHCP, enter Y, and go to Step 11.
Enter N if DHCP is not desired. Continue to step 6.
We recommend using a static IP address so that the IP address of the Mobility
A secondary IP address can be configured using the Administration Portal.