Top-Of-Form
The printer must be told where you want the top of your form to be. This
procedure must be performed the first time paper is introduced into the
printer, as well as every time new paper is loaded.
Set The Top-Of-Form
1. Raise the forms thickness lever as far as it will go. The "CLOSE PLATEN"
Figure 51. Raising the Forms Thickness Lever
message will appear on the operator panel. Press any key on the
operator panel to silence the alarm. See Figure 51.
Figure 52. TOF Indicator
Set The Top-Of-Form
Forms Thickness Lever
Left Tractor Door
TOF Indicator
Paper Perforation
Vertical
Position Knob
61