IBM 6400-D Generation II Series Setup Manual page 49

Left Ribbon Spool
Left Ribbon
Pedestal Models
Figure 35.Cabinet and Pedestal Models, Interior View of Ribbon Installation
8. Starting from the right ribbon spool, thread the ribbon around the right
ribbon guide, under the right tractor door, between the hammer bank
cover and ribbon mask, and along the ribbon path to the left ribbon guide.
9. Place the empty spool on the left hub.
10. Press the spool down until the hub latch snaps into place.
11. Turn the left spool by hand and check to ensure that the ribbon tracks
correctly in the ribbon path and around the ribbon guides.
12. Close the forms thickness lever.
13. Continue with the next procedure to load paper in the printer.
Spool
Install The Ribbon
Cabinet Models
Forms Thickness
Lever
Forms Thickness
Lever
49