Troubleshooting - JVC GC-A70 Instructions Manual

[Back] [Next]

TROUBLESHOOTING

When the camera does not work:
Possible cause
Power unintentionally cut off.
Power cut off due to camera's
Off feature.
Battery direction is wrong.
The batteries are weak.
Battery performance deterioration due to low
temperature.
Camera is connected to PC. (When connected
to PC, the camera will not be able to shoot).
Condensation inside camera.
When the flash does not work:
Possible cause
Camera is set at the Video Clip or Play mode.
Flash is set to off.
Shooting in bright light situation.
When the LCD Monitor does not show well:
Possible Cause
The camera is held under bright sunlight.
The LCD monitor is not activated.
When you are unable to shoot:
Possible Cause
Power is low or off.
Flash re-charge after shooting is not yet
complete.
Internal or card memory full.
The card is write protected.
When you are unable to replay the images:
Possible Cause
Power is low or off.
Camera is set to the wrong mode.
The pictures have not been saved in memory.
When you are unable to
Possible Cause
The card is write protected.
When photographs turn out too bright:
Automatic Power
Use your hand to cover the monitor from sunlight. Alternatively, use the
Erase the images no longer required,
Follow the instructions in this manual, shoot again and replay.
Format or Erase:
Press the [POWER] button
Press the [POWER] button
Rearrange the batteries in the correct position.
Replace batteries.
Warm up the batteries to some extent by, for example, rubbing them
against a soft surface before use.
Detach the camera from the PC after
Dry the camera before turning on the power.
Set camera to Camera
Set to Auto/Red-eye.
The flash does not fire in bright light situation.
viewfinder.
Press the [DISPLAY]/Up
Check battery level. Replace if necessary.
Release the shutter button, wait till the
shoot again.
a new memory card.
Use a new card or disable the write protection.
(only for SD card)
Check battery level. Replace if necessary.
Set camera to Play mode.
Disable the write protection. (only for SD card)
Rectifications
to turn the camera on.
to turn the camera on.
image-data
Rectifications
mode.
Rectifications
button to activate the monitor.
Rectifications
Status Indicator
transfer them to your PC or
Rectifications
Rectifications
download.
is unlit, then
insert