Installation - Haier AC-8888-07 Service Manual

Installation

● Remove all the packing materials as shown in figure1 (including the foam base).
● Remove the packing screws as
shown in figure.2.
The packing bolts protect the
appliance from impact damage
during transportation. Follow the
steps below before using the
appliance.
1. Remove the rear panel of the
washing machine;
2. Remove the three packing bolts
from the rear panel of the washing
machine, the rubber hose and then
the shock absorption steel
Channel;
3. Refit the back plate;
4. Fill the holes left by the packing
bolts with plastic plugs.
Attention: The packing bolts and
rubber hose should be kept in a safe
place for later use)
● Adjusting the position of the
washing machine.
The washing machine is provided
with adjustable feet. Before use,
adjust the feet until the appliance is
level, as shown in figure 3.
Connecting Water Supply
Attach the end of the hose to your "water tap spigot". Ensure the correct brass
end of the hose is attached to your water supply for proper fit (fig 5). Note that
the ends are different. Also ensure that you match up cold spigot cold connection
on machine (notice 'C' and "H" indications next to connection on machine.). Now
11