Haier AC-8888-07 Service Manual page 23

3. The damaged rubber sheath of the power cord results in electric leakage.
Troubleshooting
1. Check whether the insulation of power cord is good. If not, make necessary
replacement.
2. Earth the washer safely.
3. Check the condition of rubber sheath of the power cord and wrap the damaged
parts with Insulation tape.
K. The door lock indicator does not light
Possible causes:
1. The door lock indicator is broken.
2. The wiring of micro delay switch is loose.
3. The indicator loses.
Troubleshooting
1. Replace the broken indicator.
2. Tighten the stub of micro delay switch.
3. Refasten the indicator.
L. No function or malfunction of program controller
Possible causes
1. The motor of program controller loses or the stub is sealing-off.
2. The knob of program controller is stuck.
3. Poor contact of wiring of program controller.
4. Poor contact at inner contacts of program controller (even after all the plug
wires are tightened.)
23