Creating Effects; From Keypad - Vari Lite Virtuoso User Manual

VARI LITE® - V
IRTUOSO

Creating Effects

Effects can be created using the command-line keypad, Effects Control panel, or
Effects window.
When creating effects, the current settings for the Direction, Mode, and Start buttons
will be stored upon a store operation. (For creating basic effects, you can use the
default direction, mode, and start selections.)
The default timing settings can also be used. In this case, without a specific duration
time, the effect will run until it is stopped or another event replaces it in the submaster.
Duration and cycles will be covered in the Advanced Effects chapter.
When changes have been made to an effect, *MOD* will be displayed in the Effects
select display to indicate that a store operation is necessary in order to save changes. If
a new effect is selected before storing, changes will be lost.
EFFECTS

From Keypad

Use sets and sequences to create an effect:
Note: The default set is Set 0, which contains all patched channels as a single part. If
you plan to use Set 0, programming a set will not be necessary.
Step 1. Press [Effect] [n] [Set] [n] [Seq] [n] [Enter] to define a set and sequence for
Step 2. Press [Store] [Effect] [n] to store changes.
144
™ / V ™ DX C
IRTUOSO
Indicates that a store operation is necessary
Bank 1
*MOD*
1 2 3
VL7
Color2
cc>cn
Effect n. (Changes will be reflected in Effects Control display with "Effect"
highlighted.)
U ' M
ONSOLE SER S ANUAL
Page 1 Page 2
4 5 6
23-Sep-02
Page 3 Page 4 Page 5
7 8 9 10
02. 9651.0 001 C