Positioning & Initial Set Up Of Mrw-10; Power Switch - Monitor Audio Monitor Reference Series Owner's Manual

9. Power Switch

The Mains Power Switch should be switched to the 'Off' position when the MRW-10 will not
be used for extended periods. The switch must be in the 'On' position for the subwoofer
to function.
WARNING: Due to the mains switch being located on the rear panel, the apparatus must be
located in the open area with no obstructions to access the mains switch.
10. IEC Mains Power Connector/ Fuse Location
The MRW-10 is supplied with a two-pin mains input socket for connection to the mains
supply. Use ONLY the appropriate IEC mains lead provided with the product. Also fitted is
an external mains fuse. If this fuse blows during operation a spare fuse is provided within
the fuse holder for replacement. If you wish to change the fuse, you can do this by removing
the IEC mains lead and carefully levering out the original fuse from its holder below the
IEC mains input socket (10a). If the fuse blows again it is advisable to seek help from an
authorised service agent. DO NOT attempt to re-fit a further fuse as this could result in
serious damage to the amplifier unit.
11. Mains Voltage Selector
This is factory set to your country's mains voltage specification. Do not attempt to adjust this
as this may lead to permanent damage to the product and even the risk of fire. There is a
clear plastic cover over the selector to prevent accidental adjustment.
POsITIONINg / INITIal sET uP OF MRW-10
Leave the subwoofer unplugged from the mains until the installation procedure is
completed. The subwoofer should now be sited in the most suitable position. If placed in a
corner of the room there may be excessive bass 'boom'. Once a desirable position is achieved
it is important to check if the cables are long enough to reach comfortably without being under
tension. The optimal control settings will depend entirely on your system configuration. For initial
trials set the controls as follows:
Volume Control
Frequency Control
Phase Control
Power Mode Switch
By Pass Filter Switch
Input connections can be made at this stage before the power is connected to the subwoofer.
Never connect or disconnect any leads with the subwoofer connected to
the mains.
8
Monitor Ref Manual Rev1.2.indd 8
Should be set to minimum
Should be set to the 12 o'clock position
Should be set to zero degrees
Should be set to 'On'
Should be set to the 'On' for AV and 'Off' for 2
channel listening.
Monitor Reference Series
30/03/2012 10:37:42