Abus TVAC16000B User Manual page 14

Network connection
Camera mode
Setting the alarm and loudspeaker volume
This option is only available if the monitor is on the docking station
and the network cable is connected to the docking station as well
as the router.
Press the network symbol and select whether the object should
be connected to the internet or whether the device should just be
charged.
Important: Set up the network first – find out how to do this
by referring to point 6.4.3.
Once the monitor is connected to the internet, it can not be
configured or operated. To go to the main menu, disconnect the
internet connection.
Select the required display mode, by pressing SCAN, QUAD or a
camera (Cam1-4).
SCAN Sequence display of all cameras with 5 seconds
dwelling time
QUAD Four-fold display
CAM1-4 Full screen view per camera
If you have trained 1 camera, the picture of the camera will be
shown in full screen.
If you have trained 2 – 4 cameras and the system is in SCAN
mode or full screen view, it jumps to QUAD mode automatically
after 2 minutes. Here you can see a maximum of four cameras at
the same time.
Please note that in full screen mode the device can only
record 1 camera or 2-4 cameras in QUAD mode and the recording
stops as soon as you exit this view or go to the main menu.
The system can record several cameras at the same time.
Please note that when several cameras are switched on, the
resolution is reduced and no more audio recordings can be made.
Set the volume of the alarm tone (bell symbol) or camera tone
(loudspeaker symbol) by pressing "+" and "-".
The alarm tone sounds if you have saved a timer or a reminder at
a certain time.
14
English