Travel Limits; Closing Garage Door (Down Limits) - Genie SC 1500, TriloG 1200 Operation & Maintenance Manual

3
Required Programming

TRAVEL LIMITS

WA RN I NG
people to avoid injury or damage to property.
DO NOT operate this unit from wall console before LIMITS
are set. Severe damage to the opener can occur.
MUST be engaged to carriage BEFORE setting limits.
See Installation Poster (if provided) or call Customer Service at
1-800-35GENIE or visit www.geniecompany.com
NOTE: If shuttle/bullet has NOT been engaged to carriage, do so now.
See page 17.
NOTE: You have 30 seconds to execute each step. If you see two
solid red or flashing LEDs on the Powerhead, you have run out of
time and must go back to the beginning of the step and start over. You
can restart as many times as necessary to complete each step.

Closing Garage Door (Down Limits)

1
Lift the door open by hand until the shuttle/bullet
engages the carriage on the rail.
1
1
2
Press and hold the down arrow button (-) for
2 seconds until the long LED comes on blue
(round LED remains off).
PROGRAM
–
SET
HOLD HOLD
2 seconds 2 seconds
6
PROGRAM
+
SET
3
Release down arrow button (-) and the long LED
will begin flashing.
PROGRAM
SET
4
Press and hold the down arrow button (-) until
garage door is fully closed, then release.
PROGRAM
SET
PROGRAM
SET
–
+
– +
HOLD
– +
(continued next page)