Genie SC 1500, TriloG 1200 Operation & Maintenance Manual page 19

6
Maintenance and Adjustments
ADJUSTMENT GUIDES
(continued)
Speed Settings (DC motors only)
Speed settings are pre-programmed at the factory for the maximum
speed. Speed settings should not need adjustment with this unit.
However, travel speed for the opener can be adjusted to a slower
speed in both the Open and Close directions, to minimize wear on
heavier sectional doors.
NOTE: One-piece doors are automatically set to the slowest speed
during Limits programming and cannot be adjusted.
There are 3-speed settings available for sectional doors. Please note
that speed may be affected by door weight and balance, along with
condition of door components and tracks.
Speed Adjustment
Action
1
PROGRAM
Press and hold for
about 10 seconds
or until both LEDs
SET
turn BLUE.
Then release.
2
Press twice.
3
Press and
PROGRAM
release.
SET
4
Press either until
you reach the
desired setting.
5
PROGRAM
Press and
release.
SET
6
Press either until
you reach the
desired setting.
7
PROGRAM
Press and
release.
Both LEDs FLASH SET
BLUE to confirm setting.
SPEED SETTINGS DONE
LED Indication/Result
BLUE
BLUE
BLUE
BLUE
Flashes BLUE 3 Times Flashes BLUE 3 Times
OFF OFF
Then the Current Speed setting
for OPENING travel will display.
SEE CHART IN NEXT COLUMN.
NOTE: Depending on the criteria
mentioned above, you may not
have the option to increase speed.
LOCKS IN OPENING SETTING.
Flashes BLUE
OFF
3 Times
Then the Current Speed setting
for CLOSING travel will display.
SEE CHART IN NEXT COLUMN.
NOTE: Depending on the criteria
mentioned above, you may not
have the option to increase speed.
LOCKS IN CLOSING SETTING.
FLASH BLUE
FLASH BLUE
LED indicator colors:
Speed Level
High
Medium
Low
®
NOTE: PowerLift 900, GPower
adjustments.
LOCATING SAFE-T-BEAM PAIRS:
Source (Red LED) and Sensor (Green LED)
Sun Sun
Green Green
Red Red
LED LED
LED LED
One Door One Door Two Door Two Door
Garage Garage Garage Garage
Green Green
Red Red Red Red
LED LED
LED LED LED LED
Three Door Three Door
Garage Garage
Single Garage Door
Multiple Garage Doors
in opposite directions.
NOTE: Direct sunlight creates interference with Safe-T-Beam Sensor
(Green LED). Sensor modules CAN be positioned further away from
door opening if necessary to avoid sunlight but no further off the wall to
maintain alignment with paired Source module.
Sun Sun
Green Green
Red Red
LED LED
LED LED
One Door One Door
Garage Garage
Blue Purple
OFF
Powerhead LEDs
LONG LED ROUND LED
RED
PURPLE
BLUE
™
900 openers DO NOT have speed
Green Green Green Green
Red Red Red Red
LED LED
LED LED LED LED
Green Green Green Green
LED LED LED LED
Red
RED
PURPLE
BLUE
LED LED
Red Red
LED LED
19