Adjusting Volume; Setting Time; Radio; Listening To Radio - Alpine CDE-133EBT Owner's Manual

Adjusting Volume

Turn the Rotary encoder until the desired sound is
obtained.

Setting Time

1
Press and hold AUDIOSETUP for at least 2 seconds to
activate the SETUP selection mode.
2
Turn the Rotary encoder to select GENERAL, and then
press ENTER.
AUDIO  GENERAL  DISPLAY  iPod  BLUETOOTH
3
Turn the Rotary encoder to select the CLOCK ADJ mode,
and then press ENTER.
The time indication will blink.
4
Turn the Rotary encoder to adjust the hours while the
time indication is blinking.
5
When the hour has been adjusted, press ENTER.
6
Turn the Rotary encoder to adjust the minutes while the
time indication is blinking.
7
Press and hold AUDIOSETUP for at least 2 seconds to
return to normal mode.
Notes
• To synchronise the clock to another clock/watch or radio time
announcement, press and hold ENTER for at least 2 seconds a er
setting the "hour". Minutes will reset to "00". If the display shows over
"30" minutes when you do this, the time will advance one hour.
• Pressing  will return to the previous mode.
• Pressing and holding  for at least 2 seconds will return to normal
mode.
• If no operation is performed for 60 seconds, the unit will return to
normal mode automatically.
Controllable with Remote Control
This unit can be controlled with an optional Alpine remote control.
For details, consult your Alpine dealer. Point the optional remote
control transmitter at the remote-control sensor.
Remote control sensor

Radio

SOURCE/
Rotary encoder
 
ENTER

BAND
TUNE/A.ME

Listening to Radio

1
Press SOURCE to select TUNER mode.
2
Press BAND repeatedly until the desired radio band is
displayed.
F1 (FM1)  F2 (FM2)  AM  F1 (FM1)
3
Press TUNEA.ME to select the tuning mode.
DX SEEK (Distance mode)  SEEK (Local mode) 
o (Manual mode)  DX SEEK
Note
• e initial mode is Distance mode.
Distance mode:
Both strong and weak stations will be automatically tuned in
(Automatic Seek Tuning).
Local mode:
Only strong stations will be automatically tuned in (Automatic
Seek Tuning).
Manual mode:
The frequency is manually tuned in steps (Manual tuning).
4
Press  or  to tune in the desired station.
Holding down  or  will change the frequency
continuously.

Presetting Stations Manually

1
Select the radio band and tune in a desired radio station
you wish to store in the preset memory.
2
Press and hold, for at least 2 seconds, any one of the
preset buttons (1 through 6) into which you wish to store
the station.
The selected station is stored.
The display shows the band, preset number and station
frequency memorised.
Notes
• A total of 18 stations can be stored in the preset memory (6 stations for
each band; FM1, FM2 and AM).
• If you store a station in a preset memory which already has a station,
the current station will be cleared and replaced with the new station.
Preset buttons
(1 through 6)
7
-EN