Advertisement
Problems
SWITCHING A
CHANNEL OR
SOURCE CHANGES
THE VOLUME
THERE IS NOISE OR
TRASH PIXELS ON
THE SCREEN
TIPS FOR HIGH
DEFINITION USERS
TIPS FOR
LETTERBOX
CONTENT USERS
I CANNOT FIND THE
VOLUME AND
CHANNEL
CHANGING
BUTTONS
TV TURNS OFF
AUTOMATICALLY
AFTER 10 MINUTES
Solutions
Different channels and inputs will sometimes have this effect
because the channel signal's own volume is already loud.
There is no way remove this completely. The TV has an
AUTO VOLUME LEVEL function that can combat this type of
effect. Please make sure that function is turned on.
When your TV's resolution is higher than the digital channel's
broadcast resolution, the signal is up-converted to match your
TV's resolution. Up-converting can cause this type of effect.
The TV is an ideal platform for viewing High Definition
Content. The best image quality can be achieved by HDMI,
YPbPr (Component), then VGA. However, due to variances in
broadcast practices, it is possible some image distortions can
occur.
Letterboxed (Widescreen) versions of DVD movies are most
commonly formatted for standard 4:3 TVs. The TV has the
capability of expanding this content so the entire screen is
filled at the expense of the image proportion. To use this
function press the aspect button on the remote control and
cycle among the available options.
The buttons are represented by the ▲▼◄► buttons located
on the remote control. ▲▼ changes the channels and ◄►
changes the volume.
The TV features a power saving mode which will automatically
turn off the TV, if there's no signal provided for more than 10
minutes.
- 35 -
Advertisement
Need help?
Do you have a question about the PLCD3956A and is the answer not in the manual?
Questions and answers
there are some buttons in the directions but not corresponding with remote
The ProScan PLCD3956A TV follows NEC’s universal remote code, meaning a universal remote may require specific codes to function correctly. If some buttons do not match, it could be due to differences in remote programming, incorrect codes, or an incompatible universal remote.
This answer is automatically generated
won't turn on with remote or power button
The ProScan PLCD3956A may not turn on with the remote or power button due to several reasons:
1. Remote Issues:
- The batteries may be dead or not properly installed. Remove and reinstall the batteries after holding the power button for about 2 seconds.
- Ensure there is a clear line of sight between the remote sensor on the TV and the remote control.
2. Power Indicator:
- Check the indicator light. If it's red, the TV is plugged in but not on. If it's green, the TV is on.
3. Power Source:
- The TV must be connected to the correct power source. Using the wrong power source may cause failure to turn on.
- Make sure the power cord is securely connected and not damaged.
4. Safety Shutoff:
- If the TV was unplugged due to a lightning storm or for a long period, reconnect it and try powering it on again.
If none of these steps resolve the issue, the TV may require service.
This answer is automatically generated