4 Electrical Wiring - Heatilator C40 Installation Manual

4
Electrical Wiring
NOTICE: The manual override switch, rheostat speed
control and cover plate are supplied. You will need to supply:
14-3 wire with ground; 14-2 wire with ground; standard wall
mount junction box; wire nuts.
• Re ove un tion o
si e o t e re la e
• rea t e 14-3 it
it t e strain relie on t e over late
• Mat olors to ire arness re to re
et an se ure it
M a t c h c o l o r s t o w ir e
h a r ne s s ( r e d t o r e d ,
w h it e t o w h it e , e t c ) a nd
s e c u r e w it h a w ir e nu t
Figure 4.1 Fan Wiring Diagram
Heatilator • C40 Constitution • 480-2340 Installation Manual • Rev D • 05/30/13
over late on t e otto
roun ire t rou t e o enin
ite to
ire nuts
1 4- 3 w /g r o u nd
P o w e r t o t h e F ir e p l a c e
S na p D is c
b y p a s s s w it c h
NOTICE: Wiring for fans must be done before framed
enclosure is completed. If using a Heat Zone kit, it also must
be installed before enclosure is complete.
WARNING! Risk of Fire! DO NOT apply combustible fin-
ri t
ishing materials over any part of the front of this fireplace.
• The metal fireplace face may only be covered with
noncombustible materials such as ceramic tile, brick,
ite
or stone.
• Do not cover or block any cooling air slots.
S t a nd a r d w a l l m o u nt w it h
J u nc t io n B o x
1 4- 2 w /g r o u nd
W I R E N U T
W H I T E
W H I T E
G R E E N
R E D
B L A C K
I nc o m ing P o w e r
( 1 1 0 V )
21