Heatilator C40 Installation Manual page 19

Installation
• Re ove t e no out or over late ro
re la e an is ar it
• Cut a 3 in
t e i ensions s o n in i ure 3 14
3- 1 3/ 1 6 in.
(9 7 mm)
3- 1 / 8 in. (7 9 mm)
C L
Figure 3.14
• Deter ine t e ne essar len t o starter i e ro
a le 3 1 an ut as re uire
Table 3.1
Run Length
20 - 40 ft (6-12 m)
*A minimum of 2 in. (51 mm) pipe must be used to
cover the raw insulation to prevent it from blowing
out through the return air grille.
10 - 20 ft (3 - 6 m)
3 - 10 ft (1 - 3 m)
**
Use full 16 in. (406 mm) as supplied
NOTE: It is important the pipe length be adhered to
or it will affect the performance of your fireplace.
• n t e ountin late
li e t e ta s over t e outsi e o t e starter i e
it our s eet etal s re s in lu e in asteners
a a e i ure 3 15
Heatilator • C40 Constitution • 480-2340 Installation Manual • Rev D • 05/30/13
t e to o t e
ee i ure 3 14
ole in t e insulation oar as er
A d a p t e r
M o u nt ing
P l a t e
S t a r t e r P ip e
K no c k o u t
Cut Pipe
2 in. (51 mm)*
8 in. (203 mm)
No cut needed**
an en t e ta s o n ar
Figure 3.15
• li e t e starter i e into t e re la e
oles in t e late to t e oles in t e re la e
• la e t e a a ter on t e
sin our s eet etal s re s in lu e in t e it se ure
t e a a ter an
se urin to t e re la e ta e o n t e a a ter e
to t e to o t e re la e it alu inu
lea a e
• Deter ine t e lo ation or t e air re ister an
ousin asse
34
or oor oists
ounte to t e a
i ure 3 1
t e
NOTICE:
accessible for servicing per local code requirements.
NOTICE:
the front of the housing will protrude approximately 1/4
in. (6 mm) from the finished wall.
• tta enou
our installation to t e an ousin
90° elbows is recommended. e urel t ist lo
- ent to t e a a ter
lso s re
ousin
o no reater t an 4 t 1
WARNING! Risk of Fire!
clearances specified.
•
A minimum 1 in. (13 mm) air clearance must be
maintained at the back and 1 in. (25mm) to the sides
e ure of the fireplace assembly.
ountin
ountin late into re la e
l Cut a -5/8 in
ole et een ra in
e ra ets an e rotate 180 an
si e o t e 2 4 i ne essar
The fan and electrical connections must be
If the fan housing is installed in a 2 x 4 wall,
in 152 - ent as re uire
t e - ent to t e outlet o on t e an
ee i ure 3 1 u
as re uire
Comply with all minimum
at in t e
late linin u oles
ter
es
ta e to revent
an
13-5/8 in 143
e ers all stu s
ee
or
A maximum of (4)
t e
ort u t at intervals
lo al o e
1