Memory Expansion; Installing Memory Module - Toshiba Qosmio G10 User Manual

Optional Devices

Memory expansion

You can install additional memory in the computer's memory module
socket to increase the amount of RAM. This section describes how to
install and remove a memory module.
■
Use only memory modules approved by TOSHIBA.
■
Do not try to install or remove a memory module under the following
conditions. You can damage the computer and the module. Also, data
will be lost.
a. The computer is turned on.
b. The computer was shut down using the Standby mode or
c. Wake-up on LAN is enabled.
■
Some memory modules can be physically installed but are not
compatible with the computer. In this case, the computer will issue a
warning. When you turn on the power, a series of short beeps will
sound in the pattern of one, three, three, one. Shut down the power
and remove the incompatible module.
■
Be careful not to let screws or other foreign matter fall into the
computer. It could cause malfunction or electric shock.
Use a point size 0 Phillips screwdriver to remove and fasten the screws.
Use of an incorrect screwdriver can damage the screw heads.

Installing memory module

There are slots for two memory modules, one over the other. The
procedures are the same for installing either module.
1. Set the computer to boot mode and turn the computer's power off.
Make sure the Power indicator is off.
2. Remove AC adaptor and all cables connected to the computer.
3. Turn the computer upside down and remove the battery pack. Refer to
Replacing the battery pack
4. Loose a screw securing the memory module cover. The screw is
attached to the cover to prevent it from being lost.
9-10
Hibernation mode.
section in Chapter 6, Power, for details.
User's Manual