Toshiba Qosmio G10 User Manual page 139

You can override the settings and manually select a boot device by
pressing one of the following keys while the computer is booting:
*1
Only the model with two HDDs is supported.
*2
In this computer, CD-ROM refers to the Fixed optical media drive.
To change the boot drive, follow the steps below.
1. Hold down F12 and boot the computer.
2. The following menu will be displayed with the following icons: Built-in
HDD1, Built-in HDD2, CD-ROM, FDD, Network (LAN), boot.
A bar will appear only under the selected device.
3. Use the left/right cursor keys to highlight the boot device you want and
press Enter.
■
If a supervisor password is set only, it is the following.
■
■
■
If the supervisor and user password are set, it is the following.
■
■
■
■
The selection method above does not change the boot priority settings
in HW Setup.
■
If you press a key other than one of those above or if the selected
device is not installed, the system will boot according to the current
setting in HW Setup.
User's Manual
U Selects the USB floppy disk drive.
N Selects the Network.
1 Selects the primary HDD1.
2
Selects the primary HDD2
C
Selects the CD-ROM
The menu above appear when you use the user password to start
the computer (able to run HW Setup).
The menu above does not appear when you use the user password
to start the computer (unable to run HW Setup).
The menu above appear when you use the supervisor and user
password to start the computer (able to run HW Setup).
The menu above does not appear when you use the user password
to start the computer (unable to run HW Setup).
The menu above appear when you use the supervisor password to
start the computer (unable to run HW Setup).
*1
.
*2
.
HW Setup
7-3