5. Slide your fingernail or a thin object under the cover and lift it off.
Memory module cover
6. Fit the memory module's connectors into the socket at about a 45
degree angle and push the module down until latches on either side
snap into place.
Align the notch of the memory module with that of the memory slot and
gently insert the module into the slot.
■
Be careful not to drop the screw inside the computer.
■
Do not touch the connectors on the memory module or on the
computer. Debris on the connectors may cause memory access
problems.
7. Seat the memory module cover and secure it with one screw.
8. Install the battery pack. Refer to
Chapter 6, Power, for details.
9. Return your computer to the upright position.
10. Turn the computer power on and make sure the added memory is
recognized. Open System Properties in the Control Panel and click
the General tab.
Removing memory module
To remove the memory module, make sure the computer is in boot mode
then:
1. Set the computer to boot mode and turn the computer's power off.
Make sure the Power indicator is off.
User's Manual
Figure 9-9 Removing the memory module cover
Slot A
Figure 9-10 Seating the memory module
Screw
Slot B
Replacing the battery pack
Optional Devices
section in
9-11