Mechanical Disassemblies - Sanyo PLC-XL51 Service Manual

■ Mechanical disassemblies

Disassemble should be made following procedures in numerical order.
Following steps show the basic procedures, therefore unnecessary step may be ignored.
Caution:
The parts and screws should be placed exactly the same position as the original other-
Screws Expression
wise it may cause lose of performance and product safety.
(Type ) mm
Diameter x Length
The wiring method of the leads and ferrite cores should be returned exactly the same
T type M Type
Tapping screw Machine screw
state as the original, otherwise it may cause lose of performance and product safety.
1
Rear Leg removal.
1. Remove the 4 screws-A(M4x12) and remove the Rear Leg.
A
A
A
A
Rear Leg
- 20 -