Disable/Enable Event Logging - Avaya 1600 Series Installation And Maintenance Manual

Local Administrative Options

Disable/Enable Event Logging

Use the following procedure to enable or disable logging of system events.
1. While the telephone is on-hook and idle, press the following sequence of keys on the
faceplate of the telephone:
Mute 5 6 4 # (Mute L O G #)
Note:
Press the Mute button momentarily. Do not press this button while pressing other
Note:
keys/buttons.
2. After entry of the command sequence, the telephone displays the following text, depending
on the current value of the system parameter NVLOGSTAT:
Log=status
*=change #=OK
where status is the type of logging indicated by the NVLOGSTAT value, defined as:
Status is disabled when NVLOGSTAT = 0
●
Status is emergencies when NVLOGSTAT = 1
●
Status is alerts when NVLOGSTAT = 2
●
Status is critical when NVLOGSTAT = 3
●
Status is errors when NVLOGSTAT = 4
●
Status is warnings when NVLOGSTAT = 5
●
Status is notices when NVLOGSTAT = 6
●
Status is information when NVLOGSTAT = 7
●
Status is debug when NVLOGSTAT = 8
●
3. To change the logging status, press *.
Depending on the current value, the next sequential valid NVLOGSTAT value is selected
and displayed as the status. For example, if the current value is alerts (2), pressing *
changes the value to 3 (critical). If the current value is debug (8), pressing * changes the
value to 0 (disabled).
If a value different from the current NVLOGSTAT value is entered, the following text displays
left-justified at the top of the display:
Save new value?
*=no
38 1600 Series IP Telephone Installation and Maintenance Guide
#=yes