Charging The Batteries - D.T.Systems CDT 1000 PLUS Owner's Manual

All CDT PLUS Series units are equipped with
rechargeable Nickel Metal Hydride (NiMH) batteries.
NiMH batteries are not memory sensitive and do not
require depletion before recharging.
The batteries come partially charged from the factory.
However, it is recommended that the batteries are
given a full charge (about 12 hours) before initial use.
Remember - Always keep batteries away from
flammable substances (especially when charging).
When storing the unit for long periods, remember to
regularly give the batteries a full charge (12 hours)
and test your unit once every 4 to 6 weeks.
Battery Charging Procedure
1. Make sure the unit is off.
2. Plug the
standard electrical outlet.
3. Connect the splitter cable to
the charger and plug the
ends into the appropriate
units (small end in transmitter, large end in collar).
4. Charge the batteries for up to 12 hours. This can be
done either separately or simultaneously.
5. After charging, disconnect the battery charging
cables from the receptacles, securely replace the
rubber battery receptacle covers, and test unit.
WARNING: DO NOT CHARGE WHILE UNIT IS WET!

CHARGING THE BATTERIES

charger into a
10