FLIR PathFindIR User Manual page 18

3 – Getting Started
The image is shaky.
Check your mounting. The PathFindIR does not incorporate image
stabilization and must be mounted soundly and securely.
Image is dim.
Check your monitor and video connections. It is recommended that you
use separate power supplies for the PathFindIR and the local display to
make sure you have clean uninterrupted power. Also, verify the PathFindIR
is connected to the 75ohm input on the monitor. The image may be dim if
the camera is connected to an input that requires a different impedance.
The image is dark and no objects are seen.
Recycle the power and see if you get the "Splash Screen" (as seen below)
on the display. If you get the Splash Screen but no image afterwards (only
a black screen), check to make sure that the window is clear of all
obstructions (refer to the maintenance section for information on window
cleaning). If you do not see the Splash Screen, check the power input and
video output.
If you see the Splash Screen but no image afterwards, it is possible the
mechanical shutter is stuck in the on position. Contact FLIR customer
service for additional help.
Figure 3-1: Startup Splash Screen
10 04/07 334-0001-00-10, version 100