Signamax Connectivity System
If you want to reboot the router using factory default configuration
the router' s settings to default values.
4.3.4 System Information Display Function
Click System Information Display to open the Online Status page. In the example, on the
following page, both PPPoE connection is up on the WAN interface, H323 Status, MAC
address, Register Status, etc....
4.3.5 SNTP Setting Function
Click SNTP Setting
SNTP Setting to open the Online Status page. In the example, on the following page,
SNTP Setting
SNTP Setting
.
Use SNTP Setting
—When checked, Gateway uses a Simple Network Time Protocol (SNTP) to set
the date and time . The Gateway synchronizes the Gateway's time after you select the time zone.
Use SNTP Setting
, Select the time zone which Gateway was at.
www.signamax-us.com
factory default configuration, click "Apply
factory default configuration
factory default configuration
065-9066
Apply" then reset
Apply
Apply
www.signamax-eu.com