Jam 2 - Ricoh G186 Service Manual

for foreign matter.
4. If continuous clusters occur, check
whether the assembly slot between
shaft-pickup and housing-pickup opens
or is broken away.
5. If the paper feeds into the printer and
Jam 0 occurs, perform EDC Mode to
check the feed-sensor of the engine
board.
4.3.3 JAM 1
Description:
1. Paper is jammed in front of or inside the fuser.
2. Paper is stuck in the discharge roller and in the fuser just after passing through the
Actuator-Feed.
Check and Cause
1. If paper is jammed in front of or inside
the fuser.
2. If the recording paper is stuck in the
discharge roller and the fuser just after
passing through the Actuator-Feed,
Feed Actuator may be defective.
SM
The Causes and Solutions of Bad Discharge
4. Replace the Main PBA and/or Sensor.
Solution
1. Replace the SMPS or Exit-Sensor.
2. Replace the Main PBA.
3. Reassemble the Actuator-Feed and
Spring-Actuator if the movement is
bad.
4-15 G186