Fan Test - Ricoh G186 Service Manual

Function Name
The tray2 motor will run in the forward
T4 Feed Motor
direction or stop.
The procedure and content above may vary, depending on the situation.

5.2.6 FAN TEST

These functions are to check the current status of all fans.
Usage
1. Press the arrow keys " / " until "Component Test / 3.Fan Test" message is displayed
on the panel.
2. Press the "OK" key.
3. Press the arrow keys " / " to find a desired function (Refer to the table below).
4. Press the "OK" key.
5. Press the "OK" key to execute the function or the "Back" to return to the previous step.
Function
Function Name
Fuser Fan The fan will run or stop.
Check whether the fan is in locked
Fuser Fan Rdy
state.
SMPS Fan The fan will run or stop.
Check whether the fan is in locked
SMPS Fan Rdy
state.
Duplex Fan The fan will run or stop.
The procedure and content above may vary, depending on the situation.
SM
EDC (Engine Diagnostic Control) Mode
Description
Description
5-7
Display (LCD)
T Feed Motor [ON] / [OFF]
Display (LCD)
Fuser Fan [ON] / [OFF]
Fuser Fan Rdy.
[Ready] / [Not Ready]
SMPS Fan [ON] / [OFF]
SMPS Fan Rdy.
[Ready] / [Not Ready]
Duplex Fan [ON] / [OFF]
G186