Mounting - Honeywell MX7 Tecton User Manual

Mounting

The battery charger should be located in an area where it:
Is well ventilated.
l
Is not in high traffic areas.
l
Locates or orients the AC cord so that it will not be stepped on, tripped over or subjected to damage or stress.
l
Has enough clearance to allow easy access to the power port on the back of the device.
l
Is protected from rain, dust, direct sunlight or inclement weather.
l
This device is intended for indoor use only and requires an indoor AC power source. The charger is not approved for use in
Hazardous Locations.
Place the battery charger on a flat, horizontal, hard surface.
The battery charger can be mounted to a stable, vertical surface (e.g. wall) using the keyhole openings in the bottom panel of
the battery charger.
Note: Footprint is not to scale
1. Length of battery charger - 11.75 inches (in)/ 29.8 centimeters (cm)
2. Width of battery charger - 5.25 in / 13.3 cm
3. Left keyhole center to right keyhole center - 9.8 in / 25 cm
4. Distance down to keyhole center from back of battery charger - 0.75 in / 1.9 cm
5. Distance to keyhole center from side of battery charger - 1.1 in / 3.0 cm
6. Distance to keyhole center from front of battery charger - 4.25 in / 10.8 cm
Care should be taken, when inserting batteries in a vertical-mounted battery charger, that the battery is secured by the latch in
the battery charging pocket.
1-6