Table of Contents
Advertisement
Main Function (Continued)
Set and Run Schedule
The schedule function of the DMS can be set though the Web or using the upper
level controller.
Weekly/Yearly schedules can be set and the following information can be
assigned to each schedule:
Item
Schedule Period
Exception Day
Setup
Indoor unit to be
applied
Event
Each schedule can be used selectively by using the run schedule/stop schedule order.
At most 256 schedules can be set.
The indoor units can be controlled by the schedule function of
the DMS in at least 1 min. intervals.
Save Integrated Power Distribution Data
Overview
The DMS calculates and distributes the power consumed by each indoor unit by
receiving the total power usage from the power meter interface modules (SIM) and
taking into account the operation status of the indoor units.
The DMS saves at most 62 days worth of data. After 62 days, the oldest data is deleted
and the latest data is saved. This data can be viewed through the built-in Web page of
the DMS or by SNET-III.
6
E-
MIM-Doo_IB_E_25059.indd
6
Content
Starting and ending date of a schedule
Set an exception day within a schedule period to
ignore the schedule control
Select indoor units to receive schedule control
Set indoor unit operation modes
- Indoor unit On time
- Indoor unit Off time
- Set temperature
- Control mode: Heat, Cool, Dry, Fan, and Auto
- Allow/Disable the use of remote controllers
Both the On time and the Off time can not be set at
the same time and only one must be set.
Remark
At most
10 events
2006-03-21
ｿﾀﾈﾄ 7:34:43
Advertisement
Table of Contents
