Audio And Picture; There Is No Audio When Viewing Tv Channels; Mute And Connection; Secondary Audio - Motorola MTS HDTV set-top box User Manual

Audio and Picture

There is No Audio when Viewing TV Channels

Mute and Connection

Verify the button on the remote control has not been pressed. Press
MUTE
to restore sound.
Verify the set-top box audio output is connected to the TV or home theatre receiver.
If the set-top box audio output is connected to the TV, verify the
pressed.
If the set-top box audio output is connected to a home theatre receiver, verify the home theatre receiver
is set to the appropriate input source and its

Secondary Audio

Ensure you are not trying to play secondary audio on a channel that does not support secondary audio.
To check the secondary audio selection:
•
Press MENU.
•
Use the
RIGHT ARROW
•
With already highlighted press OK.
GENERAL
•
Use the
DOWN ARROW
•
Use the
RIGHT ARROW
•
Use the
ARROW BUTTON
•
"Primary Audio Program Set" message appears.
•
Press to return to Live TV.
EXIT

Volume

Ensure the volume on the TV is turned up.
Control the volume by using the
control on the TV remote control or on the TV set.
However, on some TV sets, you may have to use the TV controls to set the volume to full or slightly less
than full before using the set-top box remote control to control the volume. In this case, use the TV
controls to turn the volume all the way up, and then use the
control.
There is No Audio From the Centre and/or Surround Speakers of a Home Theatre
Receiver Connected to the MTS HDTV Set-Top Box
Not all Dolby Digital programs feature full 5.1 Surround Sound. In some cases the programs may only
contain left and right stereo audio.
Verify the S/PDIF cable is firmly connected to the set-top box and the home theatre receiver.
Verify the home theatre receiver is set to a surround sound audio mode (Dolby Digital, Dolby Pro Logic®
II, Dolby Pro Logic).
Verify the home theatre receiver is properly configured to work with all connected speakers.
MTS HDTV Service
button has not been pressed.
MUTE
to highlight <SETTINGS>.
to highlight
SECONDARY AUDIO
to highlight
USE PRIMARY AUDIO
to highlight and press OK.
SAVE
button on the set-top box remote control, not the volume
VOLUME
on the remote control
MUTE
button on the TV has not been
MUTE
and press OK.
and press OK.
button on the set-top box remote
VOLUME
27