Programming the Remote Control
The remote control requires two AA size (1.5V) batteries to work. Alkaline batteries are required for the
proper functioning of this remote.
On the back of the remote control, press the battery cover tab and remove the battery cover.
Insert two (2) AA-size batteries, matching the + and – symbols with the battery diagrams inside the
Close the battery compartment with the battery cover. Test the remote control by pressing the
key should light up to indicate that batteries are inserted properly.
Control Other Devices
In order to control other devices with your Motorola Remote Control you need to tell the remote control what
types of devices you have.
brings you through the steps needed to do this. When you do this the volume and
channels will always work on the Receiver no matter what mode you are in.
allows you to change
Sections 3 and 4
Section 1 – Program the Remote to Control Other Devices
To use the remote control for your other devices you will need to program the
to control the devices (section A). Please refer to the
of supported brands and models. If you have an integrated or combination unit, such as a TV/DVD unit,
each component of the unit will normally be programmed separately. If your device is not supported you will
need to use section B on "Using the Automatic Search".
Note: The AUX may be programmed to operate a VCR, Home Theatre In the Box (HTIB), receiver or
A. Manual Programming
Use the following steps to program the
Power on the device you want to program
Locate the 4-digit set up code for the device you want to program from the
Press and hold the appropriate mode key
Without releasing the chosen mode key, press and hold the
Release both the mode key and the
Enter the 4-digit set up code by pressing the number keys (0-9) on the remote control
The mode key will flash three times indicating correct entry and return to normal operation
When an invalid code is entered, the selected mode key will give a long flash to indicate
that you have not entered the set up code correctly
Should the remote control time-out before you complete the code setup, you will need to
Point the remote control at the programmed device and press the
The device should turn off
If it does not turn off, repeat steps 2 through 6 trying each code for your brand until you
find the correct code
Repeat steps 1 through 7 to program another device
MTS HDTV Service
key to affect multiple devices.
are optional if you want to reset any of the settings.
key – All the mode keys should flash twice
List, found in this manual, for a list
or AUX) on the remote control
Manufacture Code List