Section 2 - Set Volume, Channel And Power Options - Motorola MTS HDTV set-top box User Manual

Section 2 – Set Volume, Channel and Power Options
The defaults for your power, volume and channel control are that they always send the codes to the
Receiver not matter what mode you are in. Thus in
If you would like to change this follow these instructions:
A. Volume Control Set Up Options
The volume commands are always sent to the Receiver until the TV mode key is programmed. Then the
volume commands are sent to the TV from all mode keys. If you'd like the volume commands to still be sent
to just one device, but that it be different device (for example a home theatre setup) then follow the
instructions in I. Volume Always Controls the Same
different devices depending on which mode you are in then go to
Selected.
I. Volume Always Controls the Same Device
1. Press and hold the
2. Without releasing the
3. Release both the
programming mode
4. Enter by pressing the number keys on the remote control – The
955
indicating correct entry
5. Press the mode key that you want to always receive the volume commands – The selected mode
key will flash three times indicating successful assignment and return to normal operation
The volume commands will now go to the selected device no matter what mode you are in.
II. Volume Control Depends on Device Selected
The volume setting can also be reconfigured to independently control the volume associate with each
device. (E.g. In mode the receiver controls the audio; In
AUX
1. Press and hold the
2. Without releasing the
3. Release both the
programming mode
4. Enter by pressing the number keys on the remote control – The
955
indicating correct entry
5. Press the
ENTER
return to normal operations
B. Channel Selection Set Up Option
By default the remote control will always send channel commands to the Receiver no matter what mode you
are in. This will prevent accidental TV channel changes while in
Channel selection can also be reconfigured to independently send channel commands to different devices
depending on what mode you are in (e.g., In
Receiver; In mode the remote sends channel commands to the television). To do this, follow these
TV
instructions:
1. Press and hold the
MTS HDTV Service
DVD
Device. If you'd like the volume command sent to
key on the remote control
STB
key, press and hold the
STB
key and the key – All the mode keys will flash twice indicating
STB OK
key on the remote control
STB
key, press and hold the
STB
key and the key – All the mode keys will flash twice indicating
STB OK
key – The key will flash tree times indicating successful assignment and
STB
mode the remote sends channel command to the
STB
key on the remote control
STB
mode, the volume still controls the Receiver, etc.
II. Volume Control Depends on Device
key simultaneously
OK
STB
mode the TV controls the audio)
TV
key simultaneously
OK
STB
or modes.
TV, DVD AUX
key will flash twice
key will flash twice
20