Chapter 5 Advanced Settings; General Setting - Pioneer BDP-3110 Operating Instructions Manual

Chapter 5
Advanced settings
05

General Setting

1 When playback is stopped or open Blu-
ray disc player , display the Home Menu
screen.
Press HOME MENU.
2 Select and set Initial Setup.
Use a/b/c/ to select, then press ENTER.
3 Select the item and change the setting.
Use a/b/c/ to select, then press ENTER.
* Closing the Initial Setup screen
Press HOME MENU.
Note:
• If the item is gray, then it cann't selected.
System
To change the following system option to
personalize your BD player.
• [Screen Saver]
Turn on or Off the screen saver mode. It helps
to protect the TV screen.
{ On } - Turn on the screen saver mode: the
screen saver mode will be automatic turn on
after 10 minutes no operating program.
{ Off } - Turn off the screen saver mode.
• [Auto Power Off]
{Off} - Select this if you do not want the power
to turn off automatically.
28
{10 min}, {20 min}, {30 min} - The power will
be automatically turned off if no operation has
been performed for more than 10 minutes/20
minutes/30 minutes.
• [Disc Auto Playback]
{On} - Turn on disc auto playback mode.
{Off} - Turn off disc auto playback mode.
• [Control with HDMI]
This player supports Easylink which uses the
HDMI CEC (Consumer Electronics Control)
protocol. You can use one single remote
control to control all HDMI CEC functions of
devices that are connected through HDMI
connectors.
{On} - Turn on HDMI CEC features.
{Off} - Turn off HDMI CEC features.
• [Setup Navigator]
Set BD player's language, Resolution and
TV'S Aspect ratio.
• [Load Default]
Reset all settings of BD player to intial default
state.
- Follow the instruction on the TV screen to
confirm the default setting operation.
1. Select Load Default.
2. A dialog box pops up shown as below.
Select OK.
Load Default
Do you want to load default?
OK
3. Load Default it in progress, which may take
a while. Please wait...
4. When Load Default will be completed. TV
will display as follows:
Cancel