Pioneer BDP-3110 Operating Instructions Manual page 39

Problem
Picture freezes and the
front panel and remote
control buttons stop
working.
No picture is displayed
or picture is not output
in high definition when
playing BDs.
• Picture is disturbed
during playback.
• Picture is dark.
• Picture is stretched.
• Picture is cropped.
• Aspect ratio cannot
be switched.
Picture is interrupted.
The subtitles cannot
be switched.
Sound and picture are
not synchronized.
• No sound is output.
• Sound is not output
properly.
Check
Is the TV's aspect ratio properly set?
Is TV Aspect Ratio properly set?
Is Output Terminal properly set?
Is the disc played back in slow motion?
Is the disc played back in fast
forward or fast reverse?
Are the audio cables properly
connected?
Is the audio cable damaged?
Are the connected components (AV
receiver or amplifier, etc.) properly
set?
Remedy
• Press  to stop playback, then restart
playback.
• If the playback cannot be stopped,
press  STANDBY/ON on the player's
front panel to turn off the power, then turn
the power back on.
• If the power cannot be turned off (set to
standby), use a thin rod to press the reset
button on the main unit's front panel. The
unit restarts, at which point it is again
operable.
With some discs, it may not be possible
to output the video signals from the
VIDEO output terminal. In this case,
connect using an HDMI cable.
• This player supports Macrovision
analog copy protection technology. With
some TVs (such as with built-in video
deck), the picture will not be displayed
properly when the copy protected DVD
title is played. This is not a malfunction.
• If the player and TV are connected via a
DVD recorder/video deck, etc., the
picture will not be displayed properly due
to analog copy protection. Connect the
player and TV directly.
Read the TV's operating instructions and
set the TV's aspect ratio properly.
Set TV Aspect Ratio properly.
When video signals with a resolution of
1080i, 1080p or 720p are being output
from the HDMI OUT terminal, they may
be output with an aspect ratio of 16:9
even if TV Aspect Ratio is set to 4:3.
The picture may be interrupted when the
resolution of the recorded video signal
switches. Press HDMI to select a setting
other than Auto or Source Direct
The subtitles cannot be switched for
discs recorded on a DVD or BD recorder.
Set Output Terminal properly.
No sound is output during slow motion
play and forward and reverse scanning.
• Connect the cable properly according
to the connected devices(page 15)
• Insert the cable firmly and all the way in.
If the cable is damaged, replace it with a
new one.
Read the operating instructions of the
connected components and check the
volume, input, speaker settings, etc.
06
39