Miele CVA 5065 User Manual page 65

. . . the espresso is not hot enough.
^ Have the cups and system been
pre-warmed?
The smaller and thicker the cup, the
more important it is to pre-warm it.
^ Check the temperatures the different
types of coffee have been set to (see
"Settings: customising your machine -
Setting the temperature").
^ Check whether the brew unit is
blocked. If it is, clean it (see
"Cleaning and care - Brew unit").
. . . coffee is not dispensed, even
though the beans have been ground
and there is sufficient water in the
water container.
^ Check whether the slide control for
the fineness of the coffee is at the
finest setting, or if the amount of
coffee to be ground has been set at
the largest amount.
Because the process is time controlled,
it is possible that the process has taken
so long that there is no time left for
brewing.
^ Select a slightly coarser coffee grind
setting or a lower setting for the
amount of coffee to be ground (see
"Setting the coffee grinder" and
"Settings: customising your machine -
Setting the amount of coffee").
Problem solving guide
. . . the machine door will not close.
^ Are the containers in position
correctly?
^ It might be necessary to adjust the
door hinges (see "Installation -
Adjusting the door hinges").
. . . the steam system is switched off
but milk froth can still be made.
If the steam system is still hot, milk froth
can still be made. However, if the
steam system has cooled down after
being switched off, it will need to heat
up again before steam is available for
frothing milk.
. . . coffee preparation has been
interrupted.
If the water container empties whilst a
drink is being prepared, a message will
appear in the display to ask if you wish
for the drink preparation to continue
after the water container has been
refilled. If you do not respond to this
question with "OK" within 5 minutes, the
drink will be cancelled.
^ Check the plumbing to the mains
water supply.
65