Table of Contents
Advertisement
6. SPECIFICATIONS
Macro files contain the following types of commands.
SelectJtagClock(0)
Outport(3,0xFFFFD014,0x000000FF)
Outport(3,0xFFFFD00C,0x00000001)
Outport(3,0xFFFFD018,0x00000001)
SelectJtagClock(5)
Outport(3,0xFFFF101C,0x00000005)
After the above steps, the code in the Flash ROM turns on the PLL and starts operation with a CPU
clock frequency of 50 MHz.
If necessary, use the menu command "Add Flash memory" to add the above Flash memory to the list.
The following shows the dialog box for adding Flash memory.
Serial Debugging
Debugging is also possible over a serial cable connected to the serial port (CN16).
Set the terminal emulator's baud rate to 9600.
Figures 6.8 and 6.9 respectively show the serial port configuration dialog box and sample console
output for Tera Term; Figures 6.10 and 6.11, the same for HyperTerminal.
22
Figure 6.6. Initializing Evaluation Board Settings
Figure 6.7. Adding Flash Memory
EPSON
// Set JTAG clock frequency to 2 kHz
// Access I/O port
// boost clock from 32 kHz to 52 MHz
// Set JTAG clock frequency to 5 kHz
// Initialize GPIOD0/1 as MA20/21
Evaluation Board Technical Manual (Rev. 1.1e)
S1S65010
Advertisement
Table of Contents
