Table of Contents
Advertisement
6. SPECIFICATIONS
(2) Important Notes on Using PALMiCE
Use the following procedure to set up the evaluation board and PALMiCE.
(1) Boot the newest version of CSIDE and specify ARM720T Rev.4 as the CPU core.
(2) Choose the menu command "Target System Settings" and specify 5 MHz as the JTAG clock.
(3) Choose the menu command "Target System Settings"|"Initial Settings" and specify the macro
file.
(4) Under "Initial Settings", specify 3500 ms as the interval to wait after leaving the reset state.
(5) Under "Initial Settings", select the "Use low-speed clock" check box and then specify 5 MHz.
(6) Under "Initial Settings", select "Port access method" and specify the judging criteria.
(7) Specify Toshiba TC58FV5B2AFX65 for the Flash memory.
Note that changing the CPU core specification requires loading the PALMiCE program directly.
Double-clicking on the parameter file cside.cpf provides no menu command for doing so.
The following shows the screen for specifying the JTAG clock speed.
20
Figure 6.3. Specifying 5 MHz for JTAG Clock
EPSON
Evaluation Board Technical Manual (Rev. 1.1e)
(See Figure 6.3)
S1S65010
Advertisement
Table of Contents
