Epson S1S65010 Technical Manual page 26

Notes on Debuggers
This kit supports the following two debuggers.
• Multi-ICE
• PALMiCE
The debugging interface (CN1) on this evaluation board is compatible with both. The basic load module is
webcam.axf (ELF format) generated with the armcc (ARM compiler ADS 1.2 [Build 805]).
Debugger
Multi-ICE
PALMiCE
For further details on basic debugger setup, Flash ROM support, etc., refer to the debugger manual, the
Flash ROM data sheets, and any updates on the manufacturers' websites.
(1) Important Notes on Using Multi-ICE
Multi-ICE cannot be used to write to the load modules to the Flash ROM on this evaluation board
(Toshiba TC58FV5B2AFX65) because it supports only the following types of Flash ROM. Note that
PALMiCE does not have this restriction.
Debugger
Multi-ICE
PALMiCE
The Compact Flash interface (CFI) supports Intel and Fujitsu Flash ROMs.
Using Multi-ICE to download to ATMEL Flash ROMs requires changing downloaders. In its standard
configuration, this debugger supports only the Intel DT28F320 and equivalents.
Using Multi-ICE to debug code executed from ROM (as in this kit) requires at least one watch point
unit available. Use the following procedure to modify the standard AXD settings.
(1) Boot the Multi-ICE server.
(2) Boot the AXD.
(3) Choose the AXD menu command "Options"|"Configure Processor" to open the configuration
panel.
(4) Deselect all Vector catch check boxes.
(5) Deselect the Semihosting check box.
(6) Press the "OK" button to apply the new settings.
Failure to modify the above settings causes writing the load module to abort with the following
message.
S1S65010
Evaluation Board Technical Manual (Rev. 1.1e)
Table 6.3. Debugger Connections
Connections
Evaluation
PC
Board
JTAG Parallel port
JTAG USB
Table 6.4. Flash ROM Update Support
Sector
Format
128K × 32
256 × 2048
256 × 512
Configurable
Error: Too many breakpoints
Load
Module
*.axf Flash ROM updates not allowed.
*.ctx Convert with dw22ctx.
Capacity
4M DT28F320 (Intel)
512K AT29C040A (ATMEL)
128K AT29C1024 (ATMEL)
Configurable Configure to match device
EPSON
6. SPECIFICATIONS
Notes
Sample Supported Devices
19