Disassembly Instructions; Cabinet Pa 2; Front - Grundig PA 2 Service Manual

Hide thumbs Also See for PA 2:
Table of Contents

Advertisement

Allgemeiner Teil / General Section
Ausbauhinweise
1.
Gehäuse PA 2
1.1 Gehäuseseitenteile (Fig. 1.1)
Je 2 Schrauben 1 herausschrauben.
-
-
Je 1 Schraube 2 herausschrauben.
-
Gehäuseseitenteile abnehmen.
-
Zwischen dem Gehäuseseitenteil und dem Rahmen ist bei den
Schrauben 2 je 1 Scheibe untergelegt.
-
Bei der Montage die Schrauben vorsichtig anziehen, damit das
Gehäuse nicht beschädigt wird.
1.2 Gehäuserückteil 3
-
Gehäuseseitenteile abnehmen (Punkt 1.1).
-
10 Schrauben 4 herausschrauben (Fig. 1.1).
-
Gehäuserückteil 3 herausklappen (Fig. 1.2).
-
2 Steckverbinder 5 öffnen und das Kabel 6 nach hinten heraus-
ziehen (Fig. 1.2).
1.3 Gehäuseoberteil
-
Nach Entfernen der Gehäuseseitenteile und des Gehäuserück-
teils kann das Gehäuseoberteil mit dem Displayfenster nach oben
abgenommen werden.
Achtung: Kurze Steckverbindungen.
Fig. 1.1
4
3
4
1.4 Frontblende
-
Cassettenschublade ausfahren und Schubladenblende nach
oben abziehen.
-
2 Schrauben 7 (Fig. 1.3) herausschrauben.
2 Schrauben 8 und 2 Schrauben 9 (Fig. 1.4) herausschrauben.
-
-
Frontblende herunterklappen.
-
Beim Zusammenbau darauf achten, daß die „Disc/Tape Open"-
Knöpfe nicht klemmen.
Fig. 1.3
7
1 - 4
1
2

Disassembly Instructions

1.

Cabinet PA 2

1.1 Sides (Fig. 1.1)
Undo 2 screws 1 each.
-
-
Undo 1 screw 2 each.
-
Remove the sides.
-
Between the side and the frame a washer is fixed with the
screws 2.
-
When reassembling tighten the screws carefully in order to avoid
a damage of the sides.
1.2 Rear Panel 3
-
Remove sides (para 1.1).
-
Undo 10 screws 4 (Fig. 1.1).
-
Fold outward the rear panel 3 (Fig. 1.2).
-
Open the 2 connectors 5 and pull out the cable 6 to the rear
(Fig. 1.2).
1.3 Top of the Cabinet
-
After having removed the cabinet sides the cabinet top can be lifted
off together with the display window.
Attention: Short connections.
Fig. 1.2
6

1.4 Front

-
Open the cassette tray and remove the tray cover to the top.
-
Undo 2 screws 7 (Fig. 1.3).
-
Undo 2 screws 8 and 2 screws 9 (Fig. 1.4).
-
Turn down the front.
-
When reassembling take care that the „Disc/Tape Open" buttons
do not get stuck.
Fig. 1.4
8
PA 2 / PA 3
5
9
GRUNDIG Service

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Pa 3

Table of Contents