Menu Configuration-Main Menu - JVC DT-V20L3D Instructions Manual

Menu Configuration—MAIN MENU
For the operation procedure, see page 7.
Operation guide
Shows the buttons for each operation.
• The menu automatically disappears in about 30 seconds after the previous operation.
• Some items may not appear on the menu depending on the input or the input signal.
• The items controlled by the MAKE system do not appear on the menu.
PICTURE FUNCTION
Setting for the picture quality
Item To do
MOVING Reduce the lag of moving pictures which is peculiar to LCD.
1
PICTURE*
APERTURE Select the frequency of the luminance signal compensated in
2
FREQ.* "APERTURE LEVEL."
APERTURE Compensate the frequency response of the luminance signal of the
2
LEVEL* video signal.
CTI Adjust the clearness of the outlines of the chrominance signal.
LTI Adjust the clearness of the outlines of the luminance signal.
I/P MODE Selects a proper mode corresponding to the input picture.
sub menu Display the sub menu which enables you to adjust the items of "PICTURE FUNCTION" while
viewing the actual picture.
reset Restore the default settings for all the items in "PICTURE FUNCTION."
* 1 DT-V24L3D only
* 2 Memorized for each input.
Setting value: –20 – +20
BACK LIGHT
Adjusts the brightness of the display.
DVI INPUT SEL.
Setting value: AUTO, MODE1, MODE2, MODE3
When "AUTO" is selected, the format of signals come in to the DVI-D (HDCP) terminal is automatically
recognized. (Normally, select "AUTO.")
• Select "MODE1", "MODE2" or "MODE3" when the picture is not displayed correctly with "AUTO."
• DVI-D input of the monitor is compatible with HDCP.
COMPO./RGB SEL. Setting value: COMPO. (component), RGB
Selects the signal type you want to use for COMPO./RGB terminals.
10
Setting value
OFF, ON
OFF, LOW, HIGH
01 – 10
OFF, NORMAL, HARD
OFF, NORMAL, HARD
NORMAL, CINEMA,
FIELD