Removing The Reel Pulse Board And Solenoid - JVC DX-T7 Service Manual

3.4.4 Removing the flywheel
(See Fig.8, 9)
• Prior to performing the following procedure, remove the head
amplifier & mechanism control board and the main motor as-
sembly.
(1) From the front side of the cassette mechanism, remove the
slit washers attaching the capstan shaft L and R. Pull out
the flywheels backward.

3.4.5 Removing the reel pulse board and solenoid

(See Fig.10)
• Prior to performing the following procedure, remove the head amplifier & mechanism control board.
(1) Remove the screw C.
(2) Release the tab a, b, c, d and e retaining the reel pulse board.
(3) Release the tab f and g attaching the solenoid on the reel pulse board.
(4) The reel pulse board and the solenoid come off.
a
Solenoid
g
f
Fly wheel R
Fly wheel R
Capstan shaft R
d
b c
Reel pulse board
e
Fig.10
Fly wheel L
Fig.8
Fly wheel L
Capstan shaft L
Slit washer
Fig.9
C
(No.MB368)1-45