Removing The Sensor Board And Sv Resistor - JVC DX-T7 Service Manual

3.2.14 Removing the sensor board and SV resistor

(See Fig.33)
• Remove the tray assemblies, side (L), side (R) assembly and
lifter assembly.
(1) Remove the solders from the soldered sections aj on the
sensor board and remove the wires.
(2) Remove the two screws Q and take out the sensor board
with the SV resistor.
Reference:
• Remove the soldered section ap on the sensor board as re-
quired.
• When reassembling, pass the wires through the slot ak of
the sensor board as before.
Note:
When reattaching the SV. resister, fit the projection am on the
bottom of the SV. resister into slot an of the sensor slider.
1-36 (No.MB368)
Sensor board
Q
ap
Q
am
SV resistor
an
Slider
Fig.33
ak
aj
SV resistor