Removing The Heat Sink & Amp. Board; Removing The Fan Motor; Removing The Tuner Board; Removing The Rear Panel - JVC MX-GT700 Service Manual

Removing the heat sink & amp. board
Prior to performing the following procedure, remove
the metal cover and the CD changer unit.
1. Disconnect the card wire from the connector
ACW1 and the harness from the connector ACW2
and ACW6 on the amp. board.
2. Remove the four screws I attaching the heat sink
cover to the rear panel. Remove the heat sink cover.
3. Remove the four screws J attaching the heat sink
and two screws K attaching the speaker terminal to
the rear panel.
4. After moving the heat sink upward, remove the
claws. Then pull out the heat sink & amp. board
inward.

Removing the fan motor

Prior to performing the following procedure, remove
the metal cover and heat sink cover.
1. Disconnect the harness from the connector ACW5
on the amp. board.
2. Remove the two screws L attaching the fan motor to
the rear panel.

Removing the tuner board

Prior to performing the following procedure, remove
the metal cover.
1. Disconnect the card wire from the connector CON01
on the tuner board.
2. Remove the two screws M attaching the tuner board
to the rear panel.

Removing the rear panel

Prior to performing the following procedure, remove
the metal cover, CD changer unit, heat sink & amp.
board and tuner board.
1. Remove the two screws N and three screws O
attaching the rear panel.
(See Fig.8, 11 and 12)
(See Fig.8 and 12)
(See Fig.12 and 13)
(See Fig.12)
Joint2
H
Fig.10
I
Heat sink
cover
I
Fig.11
L
J
Fan motor
Heat sink
J
O
Fig.12
Main board
CON01
Fig.13
MX-GT700
(Bottom side)
Rear panel
Rear panel
M
N
K
Speaker
terminal
Rear panel
Tuner board
1-7