Removing The Front Panel Assembly - JVC DX-T7 Service Manual

3.1.2 Removing the front panel assembly

(See Figs.4 to 6)
• Remove the metal cover.
(1) From the right side of the main body, disconnect the card
wire from the connectors
main board. (See Fig.4.)
(2) From the left side of the main body, disconnect the card
wires from the connectors (CN720, CN730) on the forward
side of the main board. (See Fig.5.)
(3) Disconnect the parallel wire while releasing the lock of the
connector CN105 on the primary board in the direction of
the arrow. (See Fig.5.)
(4) Disconnect the parallel wire from the connector
the bridge board. (See Fig.5.)
(5) From the both side of the main body, remove the two
screws C attaching the front panel assembly to the main
body. (See Figs.4 and 5.)
(6) From the bottom side of the main body, remove the two
screws D attaching the front panel assembly. (See Fig.6.)
(7) From the both side of the main body, release the claws a
and remove the front panel assembly from the main body
in the direction of the arrow. (See Figs.4 to 6.)
Front panel assembly
C
a
CN740
CN740 on the reverse side of the
CN202
Main board
Fig.4
Main board
CN730
on
Primary board
CN202
Bridge board
D
Front panel assembly
CN720
C
a
Lock
CN105
Fig.5
Front panel assembly
Fig.6
(No.MB368)1-11