Figure 14. Mounting Hole Locations (Internal Drive With Rails) - Seagate STD124000N Product Manual

Chapter 3
9.9 mm
41.3 mm
(0.39 in)
(1.63 in)
2 Places
21.8 mm
(0.86 in)
2 Places
31.5 mm
(1.24 in)
2 Places
M3.0 X
4 Deep Min.
12 Places
79.4 mm
(3.13 in)
2 Places
47.6 mm
(1.87 in)
2 Places
41.2 mm 6.0 mm
(1.62 in) (0.24 in)
2 Places
Side

Figure 14. Mounting Hole Locations (Internal Drive with Rails)

Page 28
The chassis for the internal drive with rails contains threaded mounting holes for
M3.0 metric screws. The maximum length for the M3.0 screws is 4 mm. Four are
located on the bottom and six are on each side of the frame. See Figure 14.
180.6 mm
(7.11 in)
2 Places
146 mm
(5.74 in)
139.7 mm
(5.50 in)
M3.0 X
4 Deep Min.
4 Places
79.4 mm
(3.13 in)
47.6 mm
(1.87 in)
148.5 mm
(5.84 in)
Bottom
Installation
DAT Drives