Functional Description - Makita JN3200 Instruction Manual

FUNCTIONAL
DESCRIPTION
1. Stainless steel gauge 2.5 mm
(3/32")
2. Mild steel gauge 3.2 mm (1/8")
1. Lock button
2. Switch trigger
ASSEMBLY
2
1. Wrench
2. Lock nut
3. Die holder
CAUTION:
• Always be sure that the tool is switched off and unplugged before
adjusting or checking function on the tool.
Permissible cutting thickness
004776
The thickness of material to be cut depends upon the tensile strength of the
material itself. The groove on the die holder acts as a thickness gauge for
allowable cutting thickness. Do not attempt to cut any material which will not fit
into this groove.
1
2
Aluminum up to 200 N/mm
Switch action
004778
1
CAUTION:
2
• Before plugging in the tool, always check to see that the switch trigger
actuates properly and returns to the "OFF" position when released.
To start the tool, simply pull the switch trigger. Release the switch trigger to
stop.
For continuous operation, pull the switch trigger and then push in the lock but-
ton.
To stop the tool from the locked position, pull the switch trigger fully, then
release it.
CAUTION:
• Always be sure that the tool is switched off and unplugged before
carrying out any work on the tool.
Punch replacement
004783
Fit the wrench provided onto the lock nut and tap the handle lightly with a ham-
mer to loosen the lock nut. Take off the die holder and use a wrench to remove
the screw. Then remove the punch.
1
3
Max.cutting capacities
2
Steel up to 400 N/mm
Steel up to 600 N/mm 2
2
Steel up to 800 N/mm
2
006439
mm ga
3.2 10
2.5 13
1.0 20
3.5 10
5