Related Manuals for GE KM260 Series
Summary of Contents for GE KM260 Series
- Page 1 KM260 Series Carbon Monoxide Detection System Installation and User Guide Version 2.1 / April 2004...
- Page 2 Kilsen and Aritech are GE Interlogix brands. http://www.geindustrial.com/ge-interlogix/emea © 2003 GE Interlogix B.V.. All rights reserved. GE Interlogix B.V. grants the right to reprint this manual for internal use only. GE Interlogix B.V. reserves the right to change information without notice.
-
Page 3: Table Of Contents
User Guide ............................. 7 Zone module keypad........................7 Zone module keys......................... 8 Operating states..........................9 Configuration..........................9 Maintenance and Safety ........................11 System maintenance........................11 Carbon monoxide safety levels....................11 Technical Specifications ........................12 KM260 Series Carbon Monoxide Detection System... -
Page 4: Introduction
NTRODUCTION 1.1 General description The GE Interlogix carbon monoxide (CO) detection system is the ideal solution for detection of dangerous levels of CO gas in car parks and other enclosed spaces where levels of CO gas must be monitored and controlled effectively. -
Page 5: Installation Guide
Three zone line terminals: positive, negative and data. See Figure 2: Line connection. Three terminals for the ventilation output relay (EXTR. 1): common (C), normally open (NO), normally closed (NC).. Three terminals for the alarm output relay: common (C), normally open (NO), normally closed (NC). KM260 Series Carbon Monoxide Detection System... -
Page 6: System Startup
Press the Test key. This will verify the proper working of the LED display, the zone module LED indicators and the acoustic buzzer. The number of detectors installed in the zone will also be assessed. Any fault discovered will be indicated. KM260 Series Carbon Monoxide Detection System... -
Page 7: User Guide
Power on-off key / LED 100 PPM LED Mute key / LED 50 PPM LED Test key Level key * (star) key Automatic mode LED Alarm LED Manual mode LED Ventilation LED Stopped LED Fault LED Mode key KM260 Series Carbon Monoxide Detection System... -
Page 8: Zone Module Keys
Exit alarm or fault indication by pressing the * key. Indication will exit automatically if no key is pressed for 15 seconds. Level key Used to set the CO concentration level that will trigger the ventilation relay output. KM260 Series Carbon Monoxide Detection System... -
Page 9: Operating States
1 (Ventilation level 1) is displayed. Use the Level, Mode and Mute keys to modify numeric values. Use the Mute key to modify on / off values. The * key confirms the entry and displays the next option. KM260 Series Carbon Monoxide Detection System... - Page 10 Confirmation time to alarm activation (in seconds) Confirmation time to fault activation (in seconds) Number of detectors in loop Calculated automatically during test procedure after system setup. * Use the Mute key to reset alarm and ventilation values. KM260 Series Carbon Monoxide Detection System...
-
Page 11: Maintenance And Safety
The log book should be referred to regularly to ensure all faults have been repaired. The useful lifespan of GE Interlogix CO detectors is 4 years. Detectors and / or sensing elements must be serviced or replaced within this time frame. -
Page 12: Technical Specifications
Ventilation modes ..............automatic, manual, stopped Ventilation mode indication................LED indicator Alarm indication ................acoustic and LED indicator Fault warning indication ..............acoustic and LED indicator Operating temperature....................0 to 60ºC Storage temperature ................... -10 to 70ºC Maximum humidity ......................95% KM260 Series Carbon Monoxide Detection System... - Page 13 1049370...