LIGHTING INSTRUCTIONS
FOR YOUR SAFETY READ BEFORE LIGHTING
WARNING: If you do not follow these instructions exactly, a fire or explosion
may result causing property damage, personal injury or loss of life
A. This appliance does not have a pilot.
It is equipped with an ignition device
which automatically lights the burner.
Do not try to light the burner by hand.
B. BEFORE OPERATING smell all
around the appliance for gas. Be sure
to smell near to the floor because
some gas is heavier than air and will
settle on the floor.
WHAT TO DO IF YOU SMELL GAS
• Do not try to light any appliance
• Do not touch any electric switch
1. STOP! read the safety information
above on this label.
2. Set the thermostat to lowest setting.
3. Turn off all electrical power to the
appliance.
4. This appliance does not have a pilot.
It is equipped with an ignition device
which automatically lights the burner.
Do not try to light the burner by hand.
TO TURN OFF GAS TO THE APPLIANCE
1. Set the thermostat to lowest setting.
Fig. 15
• Do not use any telephone in the
building
• If you cannot reach your gas
supplier, call the fire brigade.
C. Turn off mains power to the water
heater.
D. Do not use this appliance if any part
has been under water. Immediately
call a qualified service technician to
inspect the appliance. Replace any
part of the control system and any gas
control which has been under water.
LIGHTING INSTRUCTIONS
5. Turn off the main power switch.
6. Wait 5 minutes to clear out any gas. If
you smell gas, STOP! Follow "B" in the
safety information above on this label.
If you do not smell gas go to the next
step.
7. Set the thermostat to the desired
setting.
8. Turn on main power.
2. Turn off main power switch
OPERATING INSTRUCTIONS • SECTION 5
37